When the reducer is installed, in the event the diameter of the internal pipe diameter and aperture size doesn’t match, then you should be appropriate for the neck shrinkage or expansion. After installation, so as not to affect the distribution with the velocity field, pressure loss is ultimately caused, and the measurement accuracy in the electromagnetic flowmeter is necessary. Normally, the biggest market of the cone angle can be controlled at less than 15 degrees.
Notice of installation reducer
1. If the fluid flows in the pipe, the flow changes in a small range, whether it be increased or reduced, you should use the reducer.
2. When installing kit reducer, we should attempt to avoid cavitation with the pump inlet position.
Three. When installing a reducer in the inlet position with the pump, the gas needs to be guaranteed not to be condensed from the lower position.
4. If the inlet in the pump is changed, the concentric reducer ought to be selected. In the event the pipe all the way through in to the pump, you need to pick the top flat reducer if the order is from top to bottom, you need to find the bottom flat speed reducer instead.
5. Within the installation process, the flow meter needs to be selected according to the actual flow rate in the process pipe.
0 comments:
Post a Comment